top of page

The Electrical Panel, Not the Cooking, Decides Whether Your Pasadena Kitchen Goes Induction

Pasadena Remodeler
2 minutes ago
5 min read

If you are already gutting a kitchen, the gas-versus-induction question is cheaper to settle now than at any other point in the life of the house. Our answer, for most Pasadena kitchen remodels, is induction. But the range is rarely what drives the cost. What decides the price is whether your electrical panel has room for one more big circuit, and you only find that out from a load calculation.

This piece covers our recommendation, the three electrical paths a kitchen can take, the Pasadena Water and Power rebate and the permit sign-off it requires, and the questions that come up most when people make the switch.

Our recommendation, plainly

In a full kitchen remodel, go induction. The walls and ceiling are already open, so running a dedicated 240-volt circuit to the range costs less than it ever will again. Induction is easier to keep clean, there is no open flame next to new cabinets, and the City's utility pays you a small rebate to make the switch.

Keep gas only if the main cook truly depends on flame (wok cooking and charring peppers are the usual reasons), or if the load calculation says your service is too small and you don't want to pay for an upgrade.

Even if you keep gas, rough in the circuit. Have the electrician pull a dedicated range circuit to the range location while the drywall is off and leave it ready in a box. It is the cheapest insurance in the kitchen: if you or the next owner ever switch, the job becomes an appliance swap instead of opening up finished walls. A competitor won't usually suggest wiring for an appliance you aren't buying. We think it is one of the best-value lines in a remodel scope.

What actually decides the cost: your panel

A typical 30-inch freestanding induction range wants a dedicated 120/240-volt circuit. LG's installation instructions for its LSEL6335XE induction range, for example, call for a 40-amp range cord on a separate circuit. Many older Pasadena houses, from 1910s Craftsman bungalows to 1950s Hastings Ranch houses, were built around a gas range and were never wired for an electric one. Whether yours has room is not something to guess. A licensed electrician runs a load calculation, and the result puts you on one of three paths.

1. The panel has room. Add one dedicated circuit. This is the common, inexpensive case, and it rides on the electrical permit your remodel already needs.

2. The panel is full, but the service is big enough. The electrician may be able to rebalance circuits, or the panel itself gets replaced while the service size stays the same. If your kitchen remodel also adds an opened-up wall with new lighting and outlets, this is the moment to do it.

3. The service is too small. A service upgrade is coordinated with Pasadena Water and Power and is the path with the biggest cost and the longest lead time. Before you commit to it, price a 120-volt battery-assisted range.

Battery-assisted ranges such as the Copper Charlie and the Electra plug into an ordinary 120-volt outlet and store energy in a built-in battery, so they can cook at full power without a new 240-volt circuit. According to QuitCarbon's guide to 120-volt induction stoves, they need a 120-volt outlet within 3 feet of the back of the range and 32-inch doorways to get the unit into the kitchen. Our view: they are a real answer for a panel-limited house, but they are a newer product category, so ask about the battery warranty before you buy.

On cost, we are not quoting our own prices here, because the number depends on your panel, which we check at the walkthrough. For a market reference, QuitCarbon puts a standard 240-volt induction range at about $2,500 to $7,500 plus roughly $2,000 for a new circuit, and battery-equipped models at about $4,000 to $7,000. Those are market ranges, not our quotes.

The PWP rebate, and the permit sign-off that unlocks it

Pasadena Water and Power's electric range and range/oven combo rebate pays $200 when a new electric range replaces a natural gas one, plus $20 if you buy it in Pasadena. Customers enrolled in PWP's Bill Payment Assistance program get an extra $200. The range must be new and at least 2.1 cubic feet, the rebate is limited to one per customer every 10 years, and the application must arrive within 180 days of the purchase date.

The detail people miss is the paperwork. Along with the receipt and the spec sheet, PWP asks for the "Electrical Permit: Inspection Sign-off" from a Pasadena building inspector. A range swapped in without a permit doesn't qualify. In a remodel that is easy, because the kitchen's electrical work is already on a permit; just make sure the range circuit is on it and keep a copy of the final sign-off. If you are pulling a permit on your own, the City's permit line is (626) 744-4200. Kitchen permits can also trigger other requirements, which we covered in what a Pasadena kitchen permit can ask of your bathrooms.

Nothing in a kitchen remodel forces you off gas. Pasadena's 2022 all-electric ordinance was written for certain new buildings, and single-family homes were exempt when it was adopted. The choice is yours.

Diagram showing a load calculation leading to three paths: add a 240V circuit, rework or replace the panel, or upgrade the electrical service

Questions that come up about the switch

Will my pots work?

Hold a magnet to the bottom. If it sticks firmly, the pan works on induction. Cast iron and most stainless steel pass; plain aluminum, copper and glass don't, unless they have a magnetic base.

Do I still need a range hood?

Yes. Induction removes the combustion byproducts of a gas flame, but cooking still produces grease, smoke and moisture. Plan the hood with the same care, and settle it before rough-in. Our kitchen remodel order of operations shows where that decision falls.

What happens to the gas line?

A licensed plumber caps it. If a gas water heater or furnace still uses the same line, the rest of the system stays live. Where exactly to cap it is a call for the plumber and the inspector.

Can an induction cooktop go in a stone island?

Yes; it is a cutout like any other cooktop, with a separate wall oven on its own circuit. If you are choosing the countertop material now, read our note on California's engineered stone rule first.

Does it change the cabinet plan?

A 30-inch range replaces a 30-inch range, so a straight swap doesn't. A cooktop plus a wall oven does, and it adds a second circuit. If you are weighing new boxes against new doors, see cabinet refacing vs. replacement.

Where this fits in your remodel

Decide gas or induction before electrical rough-in, and write the range circuit (or the capped rough-in) into the scope. Our remodeling contract checklist covers how to make sure it is in writing. If the kitchen is one piece of a larger project, the panel question belongs in the whole-home remodel plan, not the kitchen alone.

See how we approach kitchen remodeling in Pasadena, browse photos of our finished projects, or check our remodeling FAQ. When you're ready, call us at (626) 744-0402 and we'll start with a look at your panel.

Comments


bottom of page